Table of Contents
Advertisement
To connect power cord to machine:
1.
Press Emergency Stop/RESET button on
front of headstock, then remove electrical box
cover from back.
2.
Thread power cord through strain relief shown
in Figure 22.
Incoming Power
Strain Relief
Figure 22. Location of incoming power strain
relief.
3.
Identify L and N terminals and grounding
terminal (PE), illustrated in Figure 23, then
connect incoming hot wires and ground wire
to those terminals.
Ground
L
PE
To
Power Source
Figure 23. Incoming power wires connected
inside electrical cabinet.
Model G0791 (Mfd. Since 9/15)
N
4.
Make sure wires have enough slack between
strain relief and terminal connections so they
are not pulled tight or stretched, then tighten
strain relief to secure cord.
Note: The strain relief must be tightened
against the outer jacket of the cord. Avoid
over-tightening the strain relief or it may
crush the cord and cause a short.
5.
Test strain relief to ensure it is properly tight-
ened by pulling cord from outside box with
light-to-moderate force. When strain relief is
properly tightened, cord will not move inside
cabinet.
6.
Install NEMA 6-15 plug on other end of power
cord per plug manufacturer's instructions.
7.
Re-install main electrical box cover.
To
avoid
unexpected
Emergency Stop/RESET button pressed in
until instructed otherwise in Test Run.
8.
Plug cord into matching power supply recep-
tacle and power source as specified in Circuit
Requirements for 220V on Page 16.
start-up,
keep
-27-
Advertisement
Table of Contents
