Table of Contents
Advertisement
Recommended: Use mounting holes in cabi-
nets (see Figure 16) to mark holes in floor.
Lift machine/stand assembly out of the way
to drill holes, then re-position and anchor
assembly to floor. Shim between lathe and
chip pan as necessary to level ways at all
four corner locations. Refer to Anchoring to
Floor and Leveling on Page 25 for detailed
information.
Figure 16. Locations of cabinet mounting holes
(two on each cabinet).
16. Fully tighten hex bolts from Step 14 to secure
lathe/mill to cabinet stand.
Tip: For best results, recheck the ways in 24
hours to make sure they are still level and
have not twisted. Re-shim as required.
17. Apply bead of silicone around pedestals,
where they contact chip tray, to further reduce
possibility of fluids leaking into cabinets.
18. Attach back splash to rear of lathe with (4)
M6-1 x 10 Phillips head screws and (4) 6mm
flat washers, as shown in Figure 17.
x 4
Figure 17. Locations to secure back splash.
-24-
19. Remove drawbar cap from mill headstock
20. Insert threaded end of drawbar into mill head-
Mounting
Holes
Figure 19. Inserting drawbar into mill headstock.
21. Replace drawbar cap over head of drawbar.
(see Figure 18).
Drawbar
Cap
Figure 18. Location of drawbar cap.
stock (see Figure 19).
Do not overtighten.
Note: Purpose of drawbar cap is to secure
drawbar without restricting its rotation. If nec-
essary, loosen drawbar cap slightly until you
can rotate drawbar by hand.
Model G0791 (Mfd. Since 9/15)
Advertisement
Table of Contents
