2.
Rotate rest to desired angle, as indicated by
scale, then retighten the two hex nuts.
Tip: Use an angle gauge to initially set the
compound rest at 60° for threading, then
mark the cross slide at the 0° mark on the
scale for future reference (see Figure 59).
Angle Gauge
Figure 59. Using an angle gauge to set
compound rest to 60° for threading.
Tool Post
Figure 60. Example of tool mounted in tool post.
-48-
Compound Rest
Location For
Reference
Mark
Tool holders can be quickly loaded and unloaded
using the lock lever, and rotated by loosening the
top nut. Tools up to
⁄
" can be secured by tighten-
5
8
ing the tool holder set screws. The thumb wheel
rotates to adjust cutting tool height.
Installing Tool
Tools Needed
Open-End Wrench/Socket 27mm ...................... 1
Hex Wrench Size 5mm ...................................... 1
Model G0791 (Mfd. Since 9/15)
Qty