Leckey MyWay User Manual page 35

10.7 Saddle
• The saddle attaches into
the plastic moulding.
• Firstly, feed the pulley
straps through the
saddle. If this is not done
the straps will cause an
obstruction.
• Move the saddle upwards
so it is in a vertical position
and hook the saddle bar
into the plastic moulding.
• Pull the lever outwards at
the end of the saddle and
move the saddle forwards
and upwards, continuing to
pull the lever outwards.
• Bring the saddle right the
way round, then release
the lever. Check the
saddle has been securely
connected in at this stage.
There is an indicator to the
side of the saddle
indicator shows green the
saddle has been connected
securely; if the indicator
shows red the saddle
has not been connected
properly and this must be
done again.
• To detach the saddle,
pull the lever fully
outwards. Keep the lever
pulled out as you swing
the saddle downwards
and it detaches.
- if the
Warning – Use both hands when attaching/detaching the saddle.
Be aware of finger placement when attaching/detaching the saddle
to avoid potential for finger nipping.
Our recommended protocol is to perch the child on the saddle prior
to the harness being attached to the frame.
For users who have medical devices within/through the abdominal
wall e.g. Pegs, baclofen pump, it is recommend that the saddle is
kept in place during use. This reduces the likelihood of the harness
riding up and causing discomfort or injury.
The device's frame should be moved/controlled by placing hands
on the frame tubing or using the adult handles accessory only.
Do not attempt to move/control the frame using the upper support
unit or any other accessory.
p.35 MyWay User Manual