Leckey MyWay User Manual page 10

p.10 MyWay User Manual
8.3 Upper Support Unit |
Handling the Upper Support Unit
• Ensure overall height is
adjusted to its highest
position- see section 8.12
'Overall Height Adjustment'.
• Place one hand underneath
the red buckle on the unit.
• Hold the grey lever on the
unit with the other hand.
8.4 Upper Support Unit | Attaching the Upper Support Unit to the Frame
• Ensure brakes have been
applied to all castors -
see section 8.6
'Applying/releasing brakes'
for instructions.
• Line the spine attachment
of the upper support unit
up with the receiver slot
on the frame.
• Ensure the pulley straps on
the upper support unit are
placed in front of the frame
tubing and are not behind it.
• Then drop the upper support unit
down into the receiver slot. The grey
lever on the upper support unit should
automatically flip down into place.
If this does not happen, simply push
the lever down. To check if the upper
support unit is engaged correctly, lift
the support unit upwards. The frame
should begin to lift off the ground if
properly engaged.
Note – this section only applies
to sizes 2 and 3 as the upper
support unit does not detach
from size 1.
Warning –
the upper support
unit weighs 11kg.
Hold the upper support
unit close to the body and
adhere to normal moving
and handling procedures.
Warning – When attaching
the upper support unit,
ensure hands are positioned
as per guidance in 8.3
'Handling the upper support
unit'. Do not hold the unit
around the bottom.
Warning – if the product
needs to be lifted once the
upper support unit has been
attached to the frame, ensure
normal moving and handling
procedures are adhered to
due to the product's weight.