Leckey MyWay User Manual page 15

8.12 Upper Support Unit Adjustments | Overall Height Adjustment
• Overall height is adjusted
by pressing the button
and then the lever.
If the button is not
pressed, overall height
cannot be adjusted.
• To adjust overall height
place both index fingers in
the area where the button
is situated. Then place both
thumbs on the lever and
push button up and press
lever down. The spine will
then move up and down -
once you have achieved the
desired position, release
the lever and button. Once
the button and lever are
triggered, you may need to
lift slightly upwards before
the spine will adjust.
8.13 Upper Support Unit Adjustments | Adjustment of the Harness Connection Points
• There is a button above each of
the pulley straps – each button
corresponds to the strap below
it. Each strap also corresponds to
the matching coloured buckles
i.e. the red strap corresponds to
the red buckles and the white
strap corresponds to the white
buckles. The straps control the
buckle positioning.
• To release the straps and buckles,
push one of the buttons
pull a corresponding buckle.
You only need to pull one side
to release both buckles of the
same colour . Then repeat the
process using the other button.
The straps and buckles are now
ready for the harness to be
attached to the frame.
and
p.15 MyWay User Manual
Note – in order to operate
the overall height adjustment,
the fine height handles need
to be in their vertical, folded-
away position. Overall height
cannot be adjusted if these
handles are facing outwards
(horizontal).
Warning – do not
adjust overall height
whilst the user is in
the product.
Continued