Operating The Computer - Life Gear Xinggui 26040 Owner's Manual

OPERATING THE COMPUTER

USING YOUR COMPUTER
The computer can be activated by pressing one of the three buttons or
by pedaling. If you leave the equipment idle for 4 minutes, the power
will turn off automatically.
BUTTON FUNCTIONS:
MODE: Press the MODE button to select the functions of the computer.
Press and hold the MODE button for 3 seconds to reset all data values
to zero except the TOTAL data values.
SET: Press the SET button to set data values of TMR (TIMER), DST (DISTANCE), or
CAL (CALORIES) for target pre-setting.
RESET: Press the RESET button to reset data values of TMR (TIMER), DST (DISTANCE),
or CAL (CALORIES) to zero.
Press and hold the RESET button for 3 seconds to reset all data values to zero except the
TOTAL data values.
COMPUTER FUNCTIONS:
SCAN: Press the MODE button until the screen displays SCAN, the computer will
automatically scan each function in sequence with change every 6 seconds.
TMR (TIMER): Displays your elapsed workout time in minutes and seconds. You may also
pre-set target time in STOP mode before training. To set TIMER press the MODE button
until the screen displays TMR. Press the SET button to change the time, each time you
press the SET button time should change by 1 minute. Press the RESET button to clear
the target time to zero. The pre-set target time range is from 0:00 to 99:00 minutes. Once
you pre-set target time and then start to exercise, time starts counting down from pre-set
target time to 0:00 per 1 second backward. When the pre-set target time counts down to
0:00, time will start to count up immediately and the computer will begin beeping to remind
you.
SPD (SPEED): Displays the current training speed.
DST (DISTANCE): Displays the cumulative distance travelled during workout. You may
also pre-set target distance in STOP mode before training. To set DISTANCE press the
MODE button until the screen displays DST. Press the SET button to change the distance,
each time you press the SET button distance should change by 0.1 km. Press the RESET
button to clear the target distance to zero. The pre-set target distance range is from 0.0 to
99.90 km. Once you pre-set target distance and then start to exercise, distance starts
counting down from pre-set target distance to 0.0. When the pre-set target distance counts
down to 0.0, distance will start to count up immediately and the computer will begin beeping
to remind you.
24