Operating The Computer - Life Gear 26800 Owner's Manual

OPERATING THE COMPUTER

USING YOUR COMPUTER
The computer can be activated by pressing the buttons or by pedaling. If you leave the
equipment idle for approximately 4 minutes, the power will turn off automatically.
BUTTON FUNCTIONS:
MODE: Press the MODE button to select each function of computer.
Press and hold the MODE button for 2 seconds, all data values will clear to zero.
SET: Press the SET button to set data values of TMR (TIME), DST (DISTANCE), CAL
(CALORIE), or PULSE for target pre-setting.
RESET: Press the RESET button to clear data values of TMR (TIME), DST (DISTANCE), or
CAL (CALORIE) to zero.
Press the RESET button to clear data values of TMR (TIME), DST (DISTANCE), CAL
(CALORIE), or PULSE to zero for target pre-setting.
Press and hold the RESET button for 2 seconds, all data values will reset to zero.
COMPUTER FUNCTIONS:
SCAN: Press the MODE button until the screen displays SCAN, the computer will
automatically scan each function of TMR (TIME), SPD (SPEED), DST (DISTANCE), CAL
(CALORIE), and PULSE in sequence with change every 6 seconds.
TMR (TIME): Displays your elapsed workout time in minutes and seconds. You may also
pre-set target time in STOP mode before training. To set TMR (TIME) press the MODE
button to select TMR (TIME) which displays on the screen. Press the SET button until you
see the TMR (TIME) begin blinking. Press the SET button to set the target time, each time
you press the SET button TMR (TIME) should change by 1 minute. Press the RESET
button to clear the target time to zero. The pre-set target time range is from 0:00 to 99:00
minutes. Once you pre-set target time and then start to exercise, time starts counting down
from pre-set target time to 0:00 per 1 second backward. When the pre-set target time
counts down to 0:00, time will start to count up and the computer will beep to alert you.
SPD (SPEED): Display the current training speed.
DST (DISTANCE): Displays the accumulative distance traveled during workout. You may
also pre-set target distance in STOP mode before training. To set DST (DISTANCE) press
18