Operating The Computer - Life Gear 20460A Owner's Manual

OPERATING THE COMPUTER

SPECIFICATIONS:
TIME---------------------------------------------------- 0:00-99:59 MIN: SEC
SPEED ------------------------------------------------ 0.0-99.9 KM/H
DIST (DISTANCE) ---------------------------------- 0.00-9999 KM
CAL (CALORIES) ----------------------------------- 0.0-9999 KCAL
ODO (ODOMETER) -------------------------------- 0.0-9999 KM
(PULSE) ------------------------------------------ 40-240 BEATS/MIN
USING YOUR COMPUTER
The computer can be activated by pressing the buttons or by pedaling. If you leave the
equipment idle for approximate 4 minutes, the power will turn off automatically.
BUTTON FUNCTIONS:
MODE: Press the MODE button to select each function of computer.
Press and hold the MODE button for 3 seconds, all data values will clear to zero except the
ODO (ODOMETER) data values.
SET: Press the SET button to set data values of TIME, DISTANCE, CALORIES, or PULSE
for target pre-setting.
RESET: Press the RESET button to clear data values of TIME, DISTANCE, or CALORIES to
zero.
Press the RESET button to clear data values of TIME, DISTANCE, CALORIES, or PULSE to
zero for target pre-setting.
COMPUTER FUNCTIONS:
SCAN: Press the MODE button until the screen displays SCAN; the computer will
automatically scan the function of TIME, SPEED, DIST (DISTANCE), CAL (CALORIES),
ODO (ODOMETER), and (PULSE) every 6 seconds.
TIME: Displays your elapsed workout time in minutes and seconds. You may also pre-set
target time in STOP mode before training. To set TIME press the MODE button until you
see the TIME displays on the screen. Press the SET button to change the time, each time
you press the SET button TIME should change by 1 minute. Press the RESET button to
clear the target time to zero. The pre-set target time range is from 0:00 to 99:00 minutes.
Once you pre-set target time and then start to exercise, time starts counting down from
pre-set target time to 0:00 per 1 second backward. When the pre-set target time counts
down to 0:00, time will start to count up and the computer will begin beeping to remind
you.
SPEED: Display the current training speed.
11