Operating The Computer - Life Gear X-Kross 21030 Owner's Manual

OPERATING THE COMPUTER

SPECIFICATIONS:
TIME --------------------------------------------------- 0:00-99:59 MIN: SEC
SPEED ------------------------------------------------ 0.0-999.9 KM/H
DIST (DISTANCE) ---------------------------------- 0.00-99.99 KM
CAL (CALORIES) ----------------------------------- 0.0-999.9 KCAL
ODO (ODOMETER) -------------------------------- 0.00-99.99 KM
PULSE ------------------------------------------------- 40-200 BEATS/MIN
USING YOUR COMPUTER
The computer can be activated by pressing the button or by pedaling. If you leave the
equipment idle for 4 minutes, the power will turn off automatically.
BUTTON FUNCTIONS:
Press the button to select each function of the computer.
Press and hold the button for 3 seconds to reset all data values to zero except the
ODO (ODOMETER) data values.
COMPUTER FUNCTIONS:
SCAN: Automatically scans each function in sequence with change every 6 seconds.
NOTE: If you do not want to use the SCAN function, press the button to select one of the
other functions.
TIME: Displays your elapsed workout time in minutes and seconds.
SPEED: Displays the current training speed.
DIST (DISTANCE): Displays the cumulative distance traveled during workout.
CAL (CALORIES): Displays approximate amount of calories burned during workout.
(This data is a rough guide for comparison of different exercise sessions and should not be
used in medical treatment).
ODO (ODOMETER): Displays the total accumulative distance traveled. The ODOMETER
data values can not be clear to zero by pressing and holding the button for 3 seconds. If
you take out the batteries from the computer, the ODOMETER data values will clear to zero.
PULSE: Displays your current heart rate figures after you grip the handlebar pulse sensors
with both your hands during exercise. To ensure the pulse readout is more precise, please
always hold on to the handlebar pulse sensors with two hands instead of just with one hand
only when you try to test your heart rate figures.
HOW TO INSTALL THE BATTERIES:
1. Remove the battery cover on the back of the computer.
2. Place two size AAA batteries into the battery housing.
3. Insure batteries are correctly positioned and battery springs are in proper contact with
batteries.
4. Re-install the battery cover.
5. If the display is illegible or only partial segment appears, remove batteries and wait 15
seconds before reinstalling.
12