Table of Contents
Advertisement
Tools Required
1. PVC glue
2.
7/32" Allen Wrench
3.
Electric Drill, Phillips Drive, ½ Hex Socket Drive
4.
Ratchet with 7/16", 1/2" and 3/8" sockets
5.
7/16", 1/2" and 9/16" wrench
6.
Hammer drill with 1/4" (6 mm) masonry bit
7. Small Level
8. Tape
9. 9/16" Deep Socket
10. 3/8" (9.5 mm) Drill Bit
11. ¼" (6 mm) Drill bit
12. Pencil or marker
13. Loctite® 242 Thread Locking Compound
Rogue 2 Assembly
Place the slide runway upside down on a surface that will not scratch the slide.
1.
(TIP: Use flattened Rogue2 box to help protect slide from scratches
during assembly.)
a. Ensure the gaskets installed at the factory are
still in place. Any damaged gasket should be
replaced prior to assembly.
b. Use Anti-Seize on all hardware pieces to
prevent galling of the stainless steel.
c. Begin by installing the hardware through the
outside rails of the runway. Insert a (#14) 5"
Button Head Screw with a (#17) Flat Washer
though each side rail as shown in Figure 4.
Fasten each screw using a (#17) Flat Washer,
(#18) Lock Washer, and (#19) Hex nut. Do not
fully tighten at this point.
ASSEMBLY INSTRUCTIONS
FIGURE B
8
17, 18,
15, 17
17
14
19
18
17
Hide quick links:
Advertisement
Table of Contents
