Table of Contents
Advertisement
Starting with the top hose clamp, insert the PVC hose into
3.
the clamps. The clamps automatically tighten when pressure
is applied pushing the hose into the clamps.
Apply PVC glue to one socket of the (#4) PVC Ball Valve
4.
and insert the PVC hose into the valve as shown in FIGURE
L. Allow the glue sufficient time to dry. The final step is
joining the PVC Ball Valve to the water source.
GARDEN HOSE ADAPTOR INSTALLATION INSTRUCTIONS
If connecting the Rogue2 water system to the pool plumbing system is not an option you may connect the
water system to a garden hose by following the steps outlined below.
Make sure that the Rogue2 water system has been properly assembled as explained in the
1.
Rogue2 Installation Instructions. Next, apply PVC glue around the end of the garden hose
adapter indicated by the arrow in FIGURE M.
After the glue is applied quickly insert the PVC
2.
fitting into one end of PVC ball valve as shown in
FIGURE N
The final step is to thread a garden hose into the
3.
PVC garden hose adapter.
After connecting the water source to the ball valve, turn
4.
on water slowly to check for leaks
If electrical bonding is required by the local governmental regulations, it shall be done in accordance with
Article No. 680 of the current National Electrical Code or the local Code, whichever has jurisdiction. Five
(#24) 1/4" x 1/2" Sheet Metal Screws and five (#10) 1/4" x 3/4" Flat Washers are provided for this
purpose. Secure one per slide leg and one per ladder.
FIGURE L
ELECTRICAL BONDING
18
1
FIGURE M
FIGURE N
Flex Hose
4
Hide quick links:
Advertisement
Table of Contents
