On-Deck Mounting Instructions - S.R.Smith ROGUE2 Assembly And Installation Instructions Manual

ON-DECK MOUNTING INSTRUCTIONS

Bond slide per local codes (see ELECTRICAL BONDING page 18).
1.
Place a deck anchor flange over each end of the slide legs.
2.
Using the four holes on each flange as a template (see FIGURE I), mark the location of each hole
3.
on the deck, Next, drill a 5/16" (7.9 mm) diameter by 1-7/8" deep hole at each marked location.
CAUTION: Do not drill holes larger than 5/16" (7.9 mm). Maintain drill hole straight and
perpendicular for proper holding strength of anchor stud.
Raise the flange up the leg and secure in place while using a hammer to drive the (#2) 5/16"-
4.
18UNC x 2-3/4" Anchor Stud, with a (#2) 5/16" Hex Nut on top, into the hole leaving 7/8 of an inch
(22.2 mm) of the stud above the deck. Then tighten the nut until it is flush with the deck. Then,
tighten the nut approximately three turns to set the anchor stud. Finally, remove the nuts.
Secure the four flanges with (#2) 5/16" Flat Washers, (#7) 5/16" Lock Washers and the (#2)
5.
5/16"–18UNC Hex Nuts.
Using the center holes on each ladder foot as templates, mark the hole locations on the deck.
6.
Next, drill holes 5/16" (22.2 mm) diameter by 2-1/4 inches (57.1 mm) deep and secure (#2)
Anchor Studs as described in 3 & 4 above.
Secure the two ladder feet with (#2) 5/16" Flat Washers, (#7) lock washers, and the (#2) hex nuts.
7.
Be sure that the ladder maintains 15 degrees (0.26 radians) from vertical.
Drill a 1/4" (6.3 mm) diameter hole into the slide leg through the 3/8" (9.5 mm) diameter hole in
8.
the flange. Insert the (#6) 3/8" O.D. Aluminum Bushing into the hole in the deck flange and push
in until it contacts the slide leg. Now insert the (#3) 1/4"-20UNC x 2-3/4" Hex Head Cap Screws
and (#4) 1/4" x 5/8" Flat Washers through the bushing and in about a 1/2" (12.7 mm) into the hole
in the slide leg. With the cap screw in position, drill a 1/4" hole into the slide leg through the 5/16"
(7.9 mm) diameter hole in the opposite side of the deck flange. Take care not to run the drill bit
into the 1/4" bolt. Push the cap screw completely through the slide leg. Install the (#4) 1/4" x 5/8"
Flat Washers and (#5) 1/4"-20UNC Hex Lock Nuts
For In-Deck Mounting proceed to Step 19
15