Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
1) Place the slide runway upside down on a surface that will not scratch the slide. (TIP: Use
flattened Rogue2 box to help protect slide from scratches during assembly.)
a. Ensure the gaskets installed at the
factory are still in place. Any damaged
gasket should be replaced prior to
assembly.
b. Use Anti-Seize on all hardware pieces
to prevent galling of the stainless
steel.
c. Begin by installing the hardware
through the outside rails of the
runway. Insert a (#14) 5" Button Head
Screw with a (#17) Flat Washer though
each side rail as shown in Figure 4.
Fasten each screw using a (#17) Flat
Washer, (#18) Lock Washer, and (#19)
Hex nut. Do not fully tighten at this
point.
d. Next, insert the hardware through the
holes in the bottom of the runway
parts. Insert a (#15) 3.5" Hex Head
Screw with a (#17) Flat Washer though each hole as shown in Figure 4. Fasten each screw
using a (#17) Flat Washer, (#18) Lock Washer, and (#19) Hex nut.
15, 17
7
17, 18, 19
19
18
17
17
14
Figure 4
Advertisement
Table of Contents
