Applicable Standards And Codes; Assembly And Installation; Drawings; Subsequent Owners - S.R.Smith VORTEX Owner's Manual

Hide thumbs Also See for VORTEX:

Table of Contents

2. All slide components require periodic maintenance. Clean components with a

cotton cloth and a non-abrasive soap and water. Avoid harsh chemicals and

disinfectants.

3. Always read the label instructions on any cleaner carefully before applying it to a

surface.

4. Inspect the plumbing system for leaks. Freeze/Thaw cycles may cause leaks at

plumbing joints which should be repaired prior to use.

5. Check all safety labels to insure they have not peeled or been removed. Contact

S.R. Smith Customer Service (800-824-4397) for replacement labels.

6. The support structure is made from steel, is primed and powder coated with a

high quality acrylic urethane finish. However, corrosion may occur depending on

water chemistry and environmental conditions. Inspect the slide on a semi-

annual basis, sand and repair any surface rust. For touch-up paint (PN # 09-819-

1), contact S.R. Smith Customer Service (800-824-4397).

CAUTION: Because this product is manufactured from Steel, placement on a pool

with a Salt Chlorine Generator will require frequent inspection and maintenance due

to the corrosive nature of these systems with all steel alloys. It is recommended that

all slide components be rinsed daily with fresh water.

APPLICABLE STANDARDS AND CODES

The installation of the VORTEX must comply with all applicable governmental and

building codes.

All S.R. Smith VORTEX slides are inspected prior to shipment from the factory. Proper

assembly and installation is mandatory. Improper assembly and installation voids S.R.

Smith's warranty and may affect the safety of the user. It is the installer's responsibility

to ensure that the structural integrity of the concrete pad prior to installation of the slide.

All drawings in this Slide Owner's Manual (Figures 1 through 5) are for illustration

purposes only and are

The Owner's Manual must remain with the owner of the slide. If the owner changes, the

Owner's Manual shall be brought to the attention of the new owner.

NOT TO SCALE

Table of Contents