S.R.Smith ROGUE2 Assembly And Installation Instructions Manual page 11

Secure the ladder to the slide using the hardware as shown in FIGURE E. Insert a (#16) 3.5"
8.
Button Head Screw with a (#17) Flat Washer though each drilled hole. Fasten each screw using
a (#17) Flat Washer, (#18) Lock Washer, and (#20) Acorn Nut.
With the entrance way secured and the slide in relative final position. Level as close as possible
9.
the exit runway surface horizontally, from side to side, using a small level. The exit end height
should be maintained at 7" (0.178 M) between the bottom of the slide and the deck, see FIGURE
A
The legs can be adjusted up and down within the leg sockets to help adjust for level. Once the
10.
slide is properly leveled the legs shall be permanently attached by drilling a 1/4" (6 mm) hole into
each leg using the hole on the leg socket as a guide and fastening with a (#21) 5/16" Hex Head
Washer Tek Head Screw. See FIGURE F.
Step 3.
x 4 Places
Step 2.
FIGURE F
Step 3.
11