Easy Retrieve™ Backup (Information + Programs Button At Run Position) - Hunter ACC Owner's Manual

proper operation, or perform diagnostics. It also features a quick advance for stepping through
stations with the arrow button.
Test does not run SSGs or programs. It activates each individual station output in turn.
To run a Test Program:
Turn the dial to the Run position.
Press and hold in the Programs button for approximately 3 seconds.
The Test Program screen will appear below the time/date display.
4:15:13 PM
The screen will show Station 01 (and its name, if
THURSDAY 11/15/05
applicable) and the run time field will be highlighted.
To start the Test Program on a station higher than 01,
TEST PROGRAM
use the Up and Down arrow buttons to advance the
Start with station:
starting station number.
STA 01 – NW Turf
Use the +/- buttons to set the test run time, in mm:ss
Run each station:
format. The maximum run time in Test mode is 15
00:00 (MM:SS)
minutes.
Use the right and left arrow buttons to move between
WATERING AT 4:16:02 PM
the minutes and seconds fields to set the universal test
Sta Mode Time
time, and then wait a few seconds.
01 TEST 0:00:58
The Test program will begin running in 3 seconds if
no further buttons are pressed. Each station will show
the time remaining in the display.
Once the Test program is running, the stations can be
advanced or reversed without waiting for the run
times to complete. Press the right arrow button to step
up one station immediately. Press the left arrow button to back up one station (this will restart the
previous station with a new Test run time).
Easy Retrieve™ backup (INFORMATION + Programs button at Run position)
This saves the complete controller setup, including programs, start times, run times, etc., in a
safe part of the controller's memory.
Once this info is saved, it can be recalled and the controller can be restored to that condition
regardless of what has been programmed or altered since.
Once the controller is running its basic programs and settings well after initial installation, this
operation must be performed (otherwise, it cannot be recalled later). If other users alter the
watering after installation or cannot remember what changes they have made, the Easy Retrieve
function can be used to restore the controller to the original operating modes.
To save an Easy Retrieve backup: First, make sure the controller is in the desired state of
programming, including Days to Water, Start Times, Run Times, names, etc.
Turn the dial to the Run position.
ACC Owner's Manual Rev E
9/06 50 of 60