Easy Retrieve™ Backup - Hunter ACC-1200 Manual

• The Test Program will try to start ALL stations counted
by the controller. If you are running a Test Program on
a decoder controller, the Test Program will attempt to
activate all 99 stations. If you do not have 99 stations
installed in the field, this may cause multiple alarms
for decoder stations that are not present and do not
respond.
eASy retrIeVe™ bACKuP
Press the INFORMATION and Programs button at the same
time with the dial set at Run position).
This saves the complete controller setup, including
programs, start times, run times, etc., in a safe part of the
controller's memory.
Once this info is saved, it can be recalled and the
controller can be restored to that condition regardless of
what has been programmed or altered since.
Remember to save an Easy Retrieve backup after the
controller is programmed and fully operational. If other
people make unauthorized changes or don't know what
has been done to the controller times, the Easy Retrieve
restore functioncan be used to restore the controller to
the original program set up.
• To save an Easy Retrieve backup: First, make sure
the controller is in the desired state of programming,
including Days to Water, Start Times, Run Times,
names, etc.
• Turn the dial to the Run position.
• Press the Information and the Programs buttons at the
same time.
• The Easy Retrieve save screen will appear.
52
SAVE will be highlighted. Press the + button to save the
program, and a confirmation message will appear. The
Save can still be cancelled with the – button, or press + to
complete the save. The backup will be complete if + is
pressed.
• To Restore an Easy Retrieve program: Turn the dial to
the Run position.
• Press the Information and the Programs buttons at the
same time, and the Easy Retrieve screen will appear.
• Use the down arrow button to move from Save to
Restore.
• Press the + button to Restore. A confirmation
message will appear.
• Press – to cancel the Restore, or + to continue with it.
• If + is pressed to confirm, the original saved Easy
Retrieve program will replace the existing controller
information.
• If you wish to make a new backup, leave Save
highlighted and press + to create a new backup. This
will completely replace the original Easy Retrieve
backup with the new one.
• If no backup has ever been made, the Restore option
will not be shown until an Easy Retrieve backup has
first been saved.