Reset; Decoder Operations (Acc99D Versions); Connecting The 2-Wire Paths - Hunter ACC Owner's Manual

Reset

The ACC controller can be reset, erasing most programmed information. There are 5 different
levels of Reset command available, but once any of them is chosen, the information will be
permanently erased.
These operations are not reversible!
Reset should only be performed if:
a) a "clean start" is desired for programming purposes, or
b) if directed to do so by Hunter Technical Services as a troubleshooting technique.
To Reset the ACC controller: Turn the dial to the Run
position.
Press and hold the Programs button, and at the same
time press in the recessed Reset button with the tip of a
ballpoint pen. Release the Reset button and continue
holding the Programs button until the Reset Memory
screen appears (then release the Programs button).
The display will show the following Reset options:
Programs: Erases Day schedules, start times, and run times.
Flow Totals: Clears the running flow total histories (they will restart with 0.0 for all entries),
only.
Logs: Clears all alarm logs, only.
Names: Clears all user-programmed names, including Programs, Stations, and SSGs.
All Data: Clears all of the above items, and controller returns to original out-of-the-box
programming state.
Use the up and down arrows to highlight the desired type of Reset .
Press the + button to select it.
A confirmation message will appear. If + is pressed again, the selection will be reset.
None of the reset functions will erase the Easy Retrieve™ "backup", if one has been made.

Decoder Operations (ACC99D versions)

Connecting the 2-wire paths

1. Turn Controller power OFF.
2. If the decoder output module is a replacement for an
existing decoder installation, simply reconnect the 2-
wire paths to their screw terminal assignments. If
more than one path has been used, attach the original
red and blue pairs to the red and blue terminals with
ACC Owner's Manual Rev E
9/06
RESET MEMORY
_____________________________
PROGRAMS
FLOW TOTALS
LOGS
NAMES
ALL DATA
Press '+' to select
Status
LEDs
2-wire path
terminals (1-6)
Programming
Port
53 of 60