Custom Manual Program Setup (Information + Manual Operation) - Hunter ACC Owner's Manual

The first SSG will be displayed and highlighted. Change to a different SSG by pressing + or – to
move through all SSGs.
When the SSG to be edited is selected, use the down arrow to move to the stations area of the
display.
To replace a station in an SSG (with a different
station): Highlight the station to be replaced. Press
the + or – buttons to change the line to the new
station number.
To delete a station in an SSG (without replacement):
Highlight the station to be replaced, and use the + or
– buttons until the dashed line appears. This choice
appears between the highest numbered station, and
the lowest station remaining which has not been assigned to an SSG. Leave the dashed line and
move to a different field in the display with the arrow buttons.
To add a station to an SSG: Use the down arrow to move to the next blank dashed line.
Use the + or – to select the station to be added. Once all 4 lines are full (contain station numbers
or names), the SSG is full and no more can be added.
Adding an SSG
Enter the SSG Setup mode (Information + Set Program Overlap Options).
The first SSG will be highlighted.
Use the + button to advance through all existing SSGs, until the next unused SSG appears
(having all dashed lines with no station selections), and select stations as desired.
Once the controller is in ACC Setup mode, all 20 SSGs are available, whether they are used or
not.
Deleting an SSG
Technically SSGs are never deleted, as there are always 20 available.
Instead, simply select the unwanted SSG, and delete the stations contained in it until no stations
are listed under the SSG name.
SSG Flow Data
SSGs use the combined learned flow data for all their member stations. They do not have a flow
assigned directly to them. If the stations in an SSG are edited (added or deleted), the flow for the
whole SSG will change by the amount of that station.

Custom Manual program setup (INFORMATION + Manual Operation)

Custom Manual programs are "preset" irrigation sequences which do not run automatically, but
can be started at any time from the Manual Operations position. The ACC permits up to 4
Custom Manual programs.
ACC Owner's Manual Rev E
9/06
SSG SETUP
SSG 01 – Front Grass
STA 01 – NW Turf
STA 03 – NE Turf
_ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _
_____________________________
48 of 60