Controller Programming And Operation; Using The Information Button; Setting Current Date And Time - Hunter ACC Owner's Manual

Controller Programming and Operation

Using the Information button

The Information button is used to provide programming tips, summary information and/or to
unlock hidden features, depending on the dial position. If a flow meter is installed, press the
Information button (with dial in the Run position) to see actual flow at any time.
If the backlit display turns off while you are programming (it will time out after 5 minutes of
inactivity), press the Information button to relight it (to prevent accidental changing of any
settings by pressing the other keys).
Pressing and holding the Information button will change the screen to either a summary screen of
that dial position or will provide a programming tip. Releasing the button will return you to the
normal programming screen for that dial position.
Some dial positions have hidden features that are accessible by holding down the Information
button, and then turning the dial to that position. This will unlock the hidden features. Hidden
features are features that are protected from accidental re-programming because they are critical
to the proper operation of the controller. Programming these hidden features is explained in the
Hidden Features section. The ACC has the following Hidden Features:
No Water Window
Delay between Stations
Making the M/V circuit Normally On (instead of Normally Off)
Setting the Flow Sensor size and type
SSG (Simultaneous Station Group) setup
Custom Manual program setup
Test Program
Easy Retrieve™ backup

Setting current Date and Time

Three items are programmed at this position:
• Time of Day and Date, the day of the week sets automatically
• Daylight Savings time usage
• Units of measure, English or Metric
• Turn the dial to the SET CURRENT DATE/ TIME position
• Press the + or – button to change the value of the flashing cursor. Hold the button down
to advance rapidly over a large range of numbers.
• Press the arrow buttons to change cursor position. Set the hour and the minutes, then
advance to the AM/PM field. Use + or – to select AM, PM, or 24 hour clock
(international, or "military" time). If 24 hour clock is selected, Program Start Times and
other controller times will also be displayed in 24 hour format.
• Press the arrow buttons to advance and set the date in MM/DD/YY format.
ACC Owner's Manual Rev E
9/06 25 of 60