Setting Program Overlap Options; Option One: Stack Or Overlap - Hunter ACC Owner's Manual

Hide thumbs Also See for ACC:

Instructions (3 pages)

Table Of Contents

Table of Contents

However, if an automatic Program (A-F) was started Manually, it will be shut down by an active

sensor that is configured to shut down that program.

The sample display on the right shows a single active sensor alarm in process, with a range of

possible responses. The operator has pressed the + button after the FAULT display, to view

controller status.

Station 02 was running in Program A, and that Program has been Suspended (the seconds timer

would still be counting, but watering would be stopped).

Station 06 was running in Program B, and has been Paused. The seconds timer would be frozen

(and watering would be stopped).

Station 05 was running in a Custom Manual program, and the sensor would have no effect on it.

Station 05 would still be watering in Custom Manual 1.

There is no direct Override for a Clik sensor. Depending on what needs to be accomplished, the

Test program is still available (for winterization functions) and individual stations can still be

started from the Manual position.

If a sensor is alarmed, and a Manual Program start is attempted for a Program with a response for

that sensor, the display will show "CANNOT RUN MANUAL. A sensor is active for this

program." That program cannot be manually started until the sensor is reset.

If full operations must be restored when a sensor is in alarm, turn the dial to the Set Sensor

Operation position, and use +/- to change the sensor response to Off (by program).

View recent alarms, or alarm history, by turning the dial to the Data History position and

selecting Alarm Logs (see Data History).