Check The Oil Level In The Wheel Hubs; Check The Oil Level In The Vibration Bearings - Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions

5.13 Check the oil level in the
wheel hubs
Caution
!
Check the oil level in both wheel hubs.
For quality of oil refer to the "table of fuels and
lubricants".
Fig. 129
Park the machine so that the plug (1) (Fig.
l
129) is in horizontal position.
Clean the area around the plug and unscrew
l
the plug.
Check the oil level. The oil level must reach the
l
bottom edge of the bore, top up oil if neces-
sary.
Screw the plug back in tightly.
l
BW 213 D-4
Every 250 operating hours
5.14 Check the oil level in the vi-
bration bearings
Caution
!
Check only at operating temperature after run-
ning the machine approx. 1/2 hour with vibra-
tion.
Danger of bearing damage! Make sure that no
dirt falls into the exciter housing.
If a loss of oil is found perform trouble shoot-
ing, repair the drum if necessary.
For quality of oil refer to the "table of fuels and
lubricants".
Park the machine on level ground.
l
Fig. 130
Move the drum, until oil level inspection plug
l
(1) (Fig. 130) on the left hand side of the drum
is in bottom position.
Thoroughly clean the area around the level in-
l
spection and filler plug.
Unscrew level inspection plug (1).
l
Some oil should run out of the inspection bore.
If necessary unscrew oil filler plug (2) and fill in
l
some oil through the oil filler bore (2), until oil
starts to drip out through the inspection bore.
Screw oil filler (2) and level inspection plug (1)
l
back in tightly.
Repeat this inspection on the other side.
l
BOMAG 89