General Notes; Description Of Indicators And Control Elements - Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions

Indicators and Controls

3.1 General notes

If you are not yet familiar with the control and dis-
play elements on this machine you should read
this section thoroughly before starting any opera-
tion on the machine. Here all functions are de-
scribed in detail.
The section "Operation" contains only brief de-
scriptions of the individual control steps.
26
3.2 Description of indicators
and control elements
Fig. 13
No. 1 = Start switch
Position "P", "0"= Ignition off, key can be pulled
out
Position "I", "II" = Ignition on, all control and
warning lights in the instru-
ment cluster light up for 3 sec-
onds (test function). The oil
pressure warning light flashes,
charge control light and park-
ing brake warning light stay on.
The preheating control light
lights up in case of low temper-
atures.
i
Note
The engine can only be started if both travel levers
are in "neutral".
The starter switch is designed with a re-start lock.
For a new starting attempt the ignition key must
first be turned back to position "0".
Position
"START" = Turn further against spring
pressure, the engine starts,
turn the ignition key back to
position "I" once the engine
has started.
Caution
!
Run the engine warm for a short while before
starting work. Do not rev up a cold engine to
high idle speed/full load speed.
BOMAG BW 213 D-4