Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 67

Fig. 111
*
Unscrew plug 1 (Fig. 111) to release the
l
brake in the drum drive motor.
Place clamping disc (4) across the brake
l
housing (2) and turn the screw (5) into the
tapped bore (3), until it bottoms.
Turn the nut (6) down and tighten it for approx.
l
one turn. The drum must rotate freely.
After towing
Caution
!
Before detaching the tow bar block the ma-
chine with chocks to prevent unintended roll-
ing.
Turn the high pressure relief valve cartridges
l
tightly back in.
Turn all brake releasing screws of the axle
l
evenly back out, until they are light moving
again.
* only with option SN1
BW 213 D-4
Fig. 112
Turn the brake releasing screws (Fig. 112)
l
back in again, until they abut against the brake
piston.
Fig. 113
Unscrew the brake releasing screws (Fig. 113)
l
for two turns and tighten the counter nuts.
Repeat this adjustment procedure on the op-
l
posite wheel side.
Unscrew the brake releasing screw from the
l
brake* in the drum drive motor, screw the plug
back in and tighten it.
BOMAG
Operation
67