Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 136

Cab assembly before initial start-up
General safety regulations for assem-
bly
When installing the cabin to your machine you
must strictly comply with the valid accident
prevention instructions or the country specific
regulations. However, dangers for persons
and property may still arise, if:
the lifting gear used has a too low bearing ca-
l
pacity
damaged or worn lifting tackle is used
l
unqualified personnel is entrusted with the in-
l
stallation
the safety instructions are not observed
l
Each person involved in the installation of the
cabin must therefore read and comply with
these safety regulations. If necessary, the cus-
tomer must demand a written confirmation
with signature.
Moreover, the following instructions and regula-
tions must obviously also be complied with:
applicable accident prevention instructions
l
generally accepted safety and road traffic reg-
l
ulations
country specific safety regulations. It is the
l
duty of the operator to be acquainted with
these instructions and to apply these accord-
ingly. This applies also for local regulations
concerning different types of handling work.
Should the recommendations in these instruc-
tions be different from the regulations valid in
your country, you must comply with the safety
regulations valid in your country.
Changes and conversions to the cabin/
machine
Unauthorized changes to the cabin are prohibited
for safety reasons.
Original parts and accessories have been special-
ly designed for this machine. We wish to make ex-
plicitly clear that we have not tested or approved
any parts or accessories not supplied by us. The
installation and/or use of such products may have
an adverse effect on the active and/or passive
driving safety.
136
The manufacturer explicitly excludes any liability
for damage caused by the use of non-original
parts or accessories.
Notes on safety in the assembly in-
structions
Danger
!
Paragraphs marked like this highlight possible
dangers for persons.
Caution
!
Paragraphs marked like this highlight possible
dangers for machines or parts of the machine.
i
Note
Paragraphs marked like this contains technical in-
formation and hints for optimal assembly.
Environment
Paragraphs marked like this point out practic-
es for safe and environmental disposal of fuels
and lubricants as well as replacement parts.
Strictly observe the national regulations for
the protection of the environment.
Information and safety stickers/decals
on the cabin
Keep stickers/decals in good and legible condition
(see spare parts catalogue) and comply with their
meaning.
Replace damaged stickers/decals
Work on heating lines
Before starting work on heating pipes relieve any
pressure and let them cool down - danger of scald-
ing!
After completing work on the heating system of the
machine check all connections and fittings for
leaks.
Working on electric parts of the ma-
chine
Before starting to work on electric parts of the ma-
chine disconnect the battery and cover it with insu-
lating material.
BOMAG BW 213 D-4