Table of Contents
Advertisement
f.
Connect one errl of the keyboard cable to the keyboard rear mounted
modular RJ type connector.
Connect the other end of the cable to either
modular
RJ
type connector located on the control unit chassis front
panel.
g.
Connect ac power cord into the control unit chassis power receptacle.
NOTE
Color nx>nitors utilize a 115/220 Vac power cord.
Connect ac power cord into the color display unit power receptacle.
h.
With the control unit chassis/color display unit power switch placed in
the off position (0), connect the ac power cord to the ac power source.
i.
Refer to the VME/10 Microcanputer System Overview Manual, Motorola
publication number M68KVSOM, for VME/10 systan power-up and operating
instructions.
2.3
INSTALLATION PROCEDURE 2
The following installation instructions provide the user with the necessary
information to install the 67-W2420B01 Tilt/Swivel Kit on a control unit chassis
as stx>wn in Figure 2-3.
This tilt/swivel kit is designed to mount the display
unit to the control unit chassis.
10-83-1799
FIGURE 2-3.
Control Unit Chassis with Tilt/swivel Asseni>ly
2-3
Advertisement
Table of Contents
