Table of Contents
Advertisement
OIAPTER 2
VME/10 INSTALLATION
2.1 INTRODUCI'ION
An area should
be
selectErl which enables access to the control unit chassis rear
expansion card cage to facilitate cabling of peripheral equipment. Two types of
installation procErlures are described.
The first procedure is for VME/10
equiJ;XI\ent having the tilt/swivel mechanism installed on the display unit by the
factory.
The secorrl procedure is for the 67-W2420B01 Tilt/Swivel Kit to
be
installed on the control unit chassis by the user.
2.2
INSTALLATION PROCEDURE 1
This
systan
installation
procedure
pertains
to
equipment
that
has
the
tilt/swivel mechanism installa:l on a typical display unit by the factory as
shown in Figure 2-1.
10-83-1800
FIGURE 2-1.
Typical Display Unit with Tilt/Swivel Mechanism
2-1
Advertisement
Table of Contents
