Table of Contents
Advertisement
3.4 VME/10 TO PRINTER INSTALLATION
To connect the VME/10 to a Centronics-compatible
Parallel Port Module jmnper headers are prepared as
shown
in
Figure
3-4.
For
specific
details
configurations, refer to the MVME410 Dual Parallel
Motorola publication number MVME410.
NOTE
printer, the MVME410 Dual
listed in Table 3-2 and as
about
the
jumper
header
Port Module User's Manual,
The MVME410 Dual Parallel Port Module is supported
by the VME/10 VERS.Ados SYSGEN co:rrmand file.
The MVME410 is configured to operate in the VME/10 I/0 Channel at interrupt
level
1.
This is established by the VME/10 VERSAdos SYSGEN file specifically
for the MVME410.
To install the MVME410 into the I/Qnodule expansion card cage, proceed as
follows:
a.
Turn off equipment power.
CAUTION
CONNECTING MODULES WHILE POWER IS ON COULD RESULT
IN DAMAGE TO COMPONENTS ON THE MODULE.
b.
Refer to Table 3-2 and Figure 3-4 and configure the MVME410 I/Qnodule
jumper headers for port 1 printer operation and interrupt level 1.
c.
Remove one blank panel arrl insert MVME410 in desired card slot.
a.
Secure MVME410 in place with two captive screws.
e.
Connect printer device via Motorola part number M68KVMPRTCE type cable
to the MVME410 front panel connector Jl.
f.
Turn on equipment power.
g.
Refer
to
the System Generation Facility User's Manual,
Motorola
publication number M68KSYSGEN, for details on setting the parameters in
the VME/10 VERS.Ados SYSGEN cornnand file (VMESlO .SYSCMD.SA) to reflect
the desired MVME410 configuration.
3-7
Advertisement
Table of Contents
