Table of Contents
Advertisement
4.3.1 VMEh\odule I/O Cabling Method 1
This installation method enables VMEmodule P2 I/O cabling to be routed through
an unused card slot in the
VME+
I/Omodule expansion card cage.
Figure 4-6
illustrates this cabling method and is installed as follows:
a. Remove desired card cage blank panel and install peripheral connector end
of I/O cable assembly to blank panel.
b. Connect the other end of the I/O cable assembly (J2 connector end) to the
applicable VMEmodule P2 connector.
NOTE
I/O cable assembly J2 connector can
be
mounted to
card cage if desired.
Use two M2.5 x 0.45 x 8
metric screws to secure connector to card cage.
c. Configure the
VM~odule
(via jurrper headers) as required.
d. Install VMEmodule in desired "double-wide" card slot.
e. Secure VMFroodule in place with two captive screws.
f. Secure modified blank panel (containing peripheral connector end of I/O
cable assembly) in place with two screws (previously removed).
4-9
Advertisement
Table of Contents
