Omron FH Series Connection Manual page 26

7.3.3. Creating the I/O Table and setting the IP Addresses
Create the I/O table and set the IP address of the PLC.
1
If the operating mode of the PLC
is Run Mode or Monitor Mode,
change it to Program Mode by
following the steps below.
(1)Select Operating Mode -
Program from the PLC Menu
of the CX-Programmer.
(2)The dialog box on the right is
displayed. Confirm that there
is no problem and click the
Yes Button.
*Refer to Additional Information
on the previous page for the
settings concerning the dialog
display.
(3)Confirm that Stop/Program
Mode is displayed on the right
of the PLC model in the
project workspace of the
CX-Programmer.
2
Select Edit - I/O Table and Unit
Setup from the PLC Menu of the
CX-Programmer.
The PLC IO Table Window is
displayed.
7．EtherNet/IP Connection Procedure
(Project workspace)
23