Omron FH Series Connection Manual page 10

5．Applicable Devices and Device Configuration
Precautions for Correct Use
Update the CX-Programmer and Network Configurator to the versions specified in this
section or higher versions using the auto update function.
If a version not specified in this section is used, the procedures described in Section 7. and
subsequent sections may not be applicable. In that case, use the equivalent procedures
described in this document by referring the CX-Programmer Operation Manual (Cat. No.
W446) and Network Configurator Online Help.
Additional Information
For specifications of the 24 VDC power supply available for the Switching hub, refer to the
Switching Hub W4S1-series User's Manual (Cat. No. 0969584-7).
Additional Information
For specifications of the 24 VDC power supply available for the FH Sensor Controller, refer to
the Image Processing System Instruction Sheet (Cat. No. 2285550-0).
Additional Information
For specifications of the 24 VDC power supply available for the Monitor, refer to the LCD
monitor Instruction Sheet (Cat. No. 1636843-6).
Additional Information
The system configuration in this document uses USB for the connection between the
Personal computer and PLC. For information on how to install the USB driver, refer to A-5.
Installing the USB Driver of the CJ-series CJ2 CPU Unit Hardware User's Manual (Cat. No.
W472).
7