I Can't Map To A Drive; I Can't Write Or Save Files To A Drive On A Network Pc; Printer Drivers Not Found - Intel AnyPoint Wireless II Network User Manual

Troubleshooting

I can't map to a drive

I can't write or save files to a drive on a network PC

Printer drivers not found

After each of the following steps, try mapping the drive. If you still cannot
map the drive, go to the next step.
Make sure the PC sharing the drive is turned on and on the network.
1
At the PC mapping the drive, open
2
see the other PC, both PCs are on the network. If you cannot, refer to "I
can't see a network PC from another PC" on page 51.
Make sure the drive is shared. If it is not, go to the PC and share the
3
drive. See "Change drive access" on page 29.
Make sure your drives are operational. Check also that the drive access
permissions are set for
access from
Shared - Read Only
access" on page 29.
Note: After you change the drive's access to
may need to save the file to another location, close the file, reopen
it, and select
Save
The printer driver you need may not be installed on the PC trying to print.
This should be installed automatically when you map to the printer, but
some printers require manual installation.
Some printer manufacturers have their own printer installation software.
You may have to install this software on all PCs that will use the printer.
Use the CD or disk(s) that came with your printer, and follow the printer
manufacturer's instructions for installing the printer drivers. Often this
requires you to run the Windows Add Printer wizard (click
, then double-click
> Printers
page 31.
Network Neighborhood
Shared - Read Only
to
Shared - Full
again.
). See "Install printer drivers" on
Add Printer
CHAPTER 6
access. To change the drive's
, see "Change drive
Shared - Full
Start > Settings
. If you can
, you
59