Troubleshooting; I Can't See A Network Pc From Another Pc - Intel AnyPoint Wireless II Network User Manual

Troubleshooting

. . . . . . .

I can't see a network PC from another PC

Make sure the adapters and cables are installed correctly
Make sure you are logged on to the network
Make sure the PCs on the network are in the same workgroup
. . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter addresses some of the most common problems people have
with their AnyPoint™ Wireless II Network. If the information you need is
not here, check the AnyPoint Wireless II Network Online Support site at:
www.intel.com/anypoint/support/
First, make sure both PCs are turned on, and that the network adapters'
hardware and software are correctly installed. Follow these steps in order.
For information about installation and cables, refer to the Installation
Guide (the poster that came with your adapter).
Restart all the PCs on the network. When Windows* restarts, the
Network Password
settings. If it does appear, type a new user name (or accept the default),
create a password (optional), and then click
See page 15 for more information on user names and network passwords.
To verify work group settings:
Click
1 Start > Settings > Control Panel
Double-click
2 Network
Click the
3 Identification
Change the
4 Workgroup
screen may appear, depending on your previous system
Do not click Cancel!
If you click Cancel, you will
not be on the network.
.
tab.
setting to the same name on all PCs.
.
OK
.
6
Enter
51