Set Up The Anypoint™ Wireless Ii Network; Where Do I Begin; Install The Anypoint Software - Intel AnyPoint Wireless II Network User Manual

Set Up the
AnyPoint™ Wireless II Network
. . . . . . .

Where do I begin?

See "What is a
network?" on
page 2 .
See "What is
sharing and
mapping?" on
.
page 8
See "What is
Internet Sharing
Software (ISS)?"
.
on page 9

Install the AnyPoint software

. . . . . . . . . . . . . . . . . . . . . . . . . . .
There are four steps to successfully installing and configuring your
AnyPoint™ Wireless II Network:
Install the hardware and drivers and your 802.11b wireless settings.
1
Refer to the AnyPoint Wireless II Network Installation Guide (the
poster included with the adapter) for detailed, step-by-step instructions.
Install the AnyPoint Connectivity Software Suite.
2
Share drives and printers.
3
"Share drives and printers" on page 15 explains how to share your
network drives and printers for the first time.
Set up the Internet Sharing Software (ISS) server.
4
ISS also enables the Firewall and Parental Control features on the
AnyPoint Wireless II Network. See "Configure the Internet Sharing
Software (ISS) server" on page 18.
Important: If you already have BlackIce Defender* installed on your
system, you may want to choose between AnyPoint or BlackICE
Firewalls before installing your software. To help you decide, review
the table in the section"Set up the Firewall" on page 20.
Important: If you are upgrading your operating system, uninstall
your AnyPoint™ software first, perform the upgrade, then install the
AnyPoint Software.
Important:
(Windows* 2000 users)
notifying you not to install the AnyPoint Wireless II Network unless
you log in to an account that has administrative rights.
Once you've installed the hardware and drivers using the Installation
Guide, you are ready to install the software using the setup program and the
instructions from this chapter. The setup program guides you through the
You will receive a screen
2
11