I Have An Insufficient Permissions Error When Running Windows 2000 - Intel AnyPoint Wireless II Network User Manual

CHAPTER 6
Check the IP address and subnet mask on PCs running Windows*
95, Windows 98, and Windows Me
I have an insufficient permissions error when running
Windows 2000
52
Most of the time, the AnyPoint software or Windows automatically sets the
IP address and subnet mask on your PC. If you have problems, you can
manually specify an IP address.
To verify an IP address and subnet mask for your adapter:
Click then click
1 Start
In the Run box, type "winipcfg" then click
2
appears,
screen
Note: For Windows 2000 Professional, view the IP address at the
command prompt. Then type the following: command
C:> ipconfig /all.
View the
3 Intel AnyPoint Wireless II Adapter
address is in the same subnet range (such as 192.254.10.10, subnet
255.255.255.0).
If you need to change the IP address, reference the following URL,
www.intel.com/anypoint/support
want to change my adapter's IP (Internet Protocol) address."
Any user who is not a member of the Administrator's group will not have
permissions to run the AnyPoint™ software.
To add the current user to the Administrator's group:
Log on as an administrator or as a member of the Administrators group.
1
Click
2 Start > Settings > Control Panel
Double-click
3 Users and Passwords
Under Users for this computer, click the user you want to change and
4
then click
Properties
On the
5 Group Membership
Group)
Click to close all dialog boxes.
6 OK
.
Run
, and read the document entitled, "I
.
.
.
tab, click
Standard user
Troubleshooting
. The
OK IP Configuration
and verify that the
(Administrators