Assign Measurement Variable; Process Variable Value; Current Output 1 To 2 Simulation - Endress+Hauser Levelflex FMP51 Operating Instructions Manual

Levelflex FMP51, FMP52, FMP54 HART

Assign measurement variable

Navigation
Selection
Factory setting
Additional information

Process variable value

Navigation
Prerequisite
User entry
Factory setting
Additional information

Current output 1 to 2 simulation

Navigation
Description
Selection
* Visibility depends on order options or device settings
Endress+Hauser
Description of parameters
Navigation  Expert → Diagnostics → Simulation
 Expert → Diagnostics → Simulation → Assign measurement variable
• Off
• Level
*
• Interface
*
• Thickness upper layer
• Level linearized
• Interface linearized
• Thickness linearized
Off
• The value of the variable to be simulated is defined in the Process variable value
parameter (→  229).
• If Assign measurement variable ≠ Off, a simulation is active. This is indicated by a
diagnotic message of the Function check (C) category.
 Expert → Diagnostics → Simulation → Process variable value
Assign measurement variable (→  229) ≠ Off
Signed floating-point number
0
Downstream measured value processing and the signal output use this simulation value. In
this way, users can verify whether the measuring device has been configured correctly.
 Expert → Diagnostics → Simulation → Current output 1 to 2 simulation
Switch the simulation of the current output on and off.
• Off
• On
Operating menu



229