Endress+Hauser Levelflex FMP51 Operating Instructions Manual page 202

Operating menu
Value 1 to 4 display
Navigation
Description
Selection
Factory setting
Decimal places 1 to 4
Navigation
Description
Selection
Factory setting
* Visibility depends on order options or device settings
202
 Setup → Advanced setup → Display → Value 1 display
Select the measured value that is shown on the local display.
• Level linearized
• Distance
*
• Interface linearized
*
• Interface distance
*
• Thickness upper layer
• Current output 1
• Measured current
*
• Current output 2
• Terminal voltage
• Electronic temperature
*
• Measured capacitance
• Analog output adv. diagnostics 1
• Analog output adv. diagnostics 2
For level measurements
• Value 1 display: Level linearized
• Value 2 display: Distance
• Value 3 display: Current output 1
• Value 4 display: None
For interface measurements and one current output
• Value 1 display: Interface linearized
• Value 2 display: Level linearized
• Value 3 display: Thickness upper layer
• Value 4 display: Current output 1
For interface measurements and two current outputs
• Value 1 display: Interface linearized
• Value 2 display: Level linearized
• Value 3 display: Current output 1
• Value 4 display: Current output 2
 Setup → Advanced setup → Display → Decimal places 1
This selection does not affect the measurement and calculation accuracy of the device.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Levelflex FMP51, FMP52, FMP54 HART
Endress+Hauser

