Advertisement
Hardware Connections
1
AC, sources and displays
1.1)
Connect the unit as shown below. Do not connect the outputs at this stage:
allocation is done automatically during speakers setup (Step 5 of this document).
1
2
2
1
1.
Check Fuse. To replace the Fuse, make sure to disconnect the AC cord from the ISP to avoid electric shock.
2.
Connect AC cord to Power Outlet (do not turn ON now) using the earth connected cable delivered with the ISP.
3.
Connect the RJ45 LAN Network cable to the router/switch
4.
Connect appropriate Digital Sources via Coaxial or Optical
5.
Connect appropriate Analog Sources via RCA
6.
Connect your HDMI sources, all inputs support HDCP2.2
(By default, HDMI1.4 speeds on HDMI IN 1 to 4, HDMI2.0 speeds on HDMI IN 5 to 7)
7.
Connect your displays (HDMI OUT 1 is HDCP1.4, HDMI OUT 2 is HDCP2.2, same content)
1.2)
Multiple connections are possible. Take note of your sources' connections to the SP4
by using the table of part 12, where you can also nd connectors pinout.
6
7
4
3
3
8
5
4
5
6
7
&
5
Advertisement
