Advertisement
Room Calibration
6
Dirac Live ®
6.8) With the rst measurement completed, the position is changed to Green and a new position is
shown in yellow. There will be 8 additional positions of the microphone required, to complete the
capture process.
1.
Press Start when you have placed
the microphone into the expected
position.
2.
For each new measurement, the plot
will get updated.
Proceed as described in 1 and 2 above
until all 9 measurements are completed.
At anytime during the process, you
can redo a new measurement at an
i
already covered position. Click on
the position to redo and then in the
red cross. You can now press Start
again to measure this position.
Don't forget to save your project on a
!
regular basis.
3.
Then proceed to the next step.
Introduction
Setup
Measure
Optimize
Export
i
1
2
3
33
Advertisement
