Advertisement
Room Calibration
6
Dirac Live ®
6.5) In this step, you will con gure the microphone to use.
1.
The Recording device will show
which microphone is selected.
2.
Click on the arrow to check the
UMIK-1 microphone is correctly
selected.
3.
On the microphone body, take note
of the serial number 70x-xxxx and go
to the download url to get the
calibration le.
4.
Two les will be available for
download. In the case of a multi-
channel setup, we usually use the
microphone pointing upward for
constant directivity in all directions.
Select the 70xxxx_90degree.txt
le in such case.
5.
Then proceed to the next step.
All along the process, it is advised to save the design into a Project. Also, you can reuse measurements made in a Theater and
!
saved in a Project to regenerate a new set of design lter following new adjustments on the target curve for example.
Introduction
Setup
4
!
https://www.minidsp.com/products/ acoustic-measurement/umik-1
Measure
Optimize
1
2
Export
5
3
30
Advertisement
