Advertisement
Web Installer Interface
3
System setup
In the System page, you can visualise hardware and software status of the ISP, change
password for Expert and Installer access, modify the Network parameters and de ne
the access level of the Expert user level. It is also possible to backup and restore the
Con guration. Follow the Steps de ned below to con gure these settings.
2
5
Network
Passwords
6
1
Access Management
4
3
1. By default, DHCP is set to Auto. If a static IP
must be de ned, press DHCP AUTO icon.
Then enter the IP address and router
settings.
2. This area provides info on your unit with
software revision and possibility to down-
load logs for support matters.
3. Later in the con guration, it will be
possible to save the con guration as a
backup le. It will also be useful to export
the parameters for the wiring of the
Outputs. Finally, upgrade of the SP4 is done
here.
4. To complete the system page
con guration, you must click SAVE. Then,
select INPUTS.
5. De ne which aspects of con guration you
wish to grant to an expert user. If required,
you can change the passwords. Default
Expert User password is Expert.
6. This area provides info on the options and
licenses installed on the SP4.
11
Advertisement
