Emerson Mentor MP Short Manual page 64

The display examples in this section show the SM-Keypad 7 segment LED display. The
examples are the same for the MP-Keypad except that the information displayed on the
lower row on the SM-Keypad is displayed on the right hand side of the top row on the
MP-Keypad.
Figure 5-3 Display modes
Status
Mode
(Display
not
flashing)
Parameter
Mode
(Upper
display
flashing)
to select parameter for editing
* Can only be used to move between menus if L2 access has been enabled
Pr 11.44 (SE14, 0.35)
**Time-out defined by Pr 11.41 (default value = 240s).
Figure 5-4 Mode examples
Parameter
View Mode
Menu 5. Parameter 5
Pr 5.05 value
Do not change parameter values without careful consideration; incorrect values may
cause damage or a safety hazard.
WARNING
64
Timeout**
To enter Parameter
Mode, press key or
Use
* keys
To enter Edit Mode,
press key
RO R/W
parameter parameter
Edit Mode
(Character to be edited in lower line of display flashing)
Change parameter values using
Healthy Status
www.controltechniques.com
To return to
Status Mode,
press
When returning
to Parameter
Mode use the
*
keys to select
another parameter
to change, if
required
To exit Edit Mode,
press
Status Mode
Alarm Status Trip Status
Mentor MP Short Form Guide
Timeout** Timeout**
key
Temporary
Parameter
Mode
(Upper display
flashing)
key
keys.
Drive status = tripped
Trip type (UV = undervolts)
Issue Number: 5