Emerson Mentor MP Short Manual page 85

Table 7-1 SMARTCARD data blocks
Data block
1 to 499
500 to 999
Parameter sets labelled as 'Differences from default' will be much smaller than whole
parameter sets. Therefore they use a lot less memory because most applications only
require a few parameters to be changed from the default setting.
Either of these indications will tell the user that data is being transferred to or from the
SMARTCARD:
• SM-Keypad: The decimal point after the fourth digit in the upper display will flash.
• MP-Keypad: The symbol 'CC' will appear in the lower left hand corner of the display.
The card should not be removed during data transfer because the drive will trip. If a trip
occurs you must either try to transfer the data again or, in the case of a card-to-drive
transfer, the default parameters should be loaded.
Mentor MP Short Form Guide
Issue Number: 5
Type
Read / Write
Read Only
www.controltechniques.com
Example of usage
Application set-up
Macros
85