Mechanical Adjustments - Ametek Solartron Metrology Wigauge WHT User Leaflet

3.

Mechanical Adjustments

Once the gauge head has been installed its rotational position can be adjusted by approximately 180º about the mounting axis.
1. Using a 3 mm A/F Hex key, undo the M6 grub screw pictured above.
2. Rotate the gauge head to the desired position.
3. Tighten the M6 grub screw to a recommended 1.3-1.5 Nm torque.
Note
Large gauge heads may require a higher torque setting on the grub screw to prevent rotation through use.
Caution
Care must be exercised when using a large gauge head to avoid damaging the grub screw or WHT.
502848 Issue11 Wigauge User Leaflet Page 9