Transport, Loading And Unloading, Handling And Storage - Circutor Getest Instruction Manual

If any problem is noticed upon reception, immediately contact the transport
company and/or CIRCUTOR's after-sales services.

3.2.- TRANSPORT, LOADING AND UNLOADING, HANDLING AND STORAGE

The centre of gravity of some units may be found at a considerable height.
Therefore, when handling with a forklift, it is recommended that the unit be
securely fastened and that no abrupt operations are made. The unit should not
be lifted more than 20 cm off the ground.
The transport, loading and unloading and handling of the unit must be carried
out with proper precautions and using the proper manual or mechanical tools
to prevent damage to the unit.
If the unit is not to be immediately installed, it must be stored at a location
with a firm and level floor, and the storage conditions listed in the technical
features section must be observed. In this case, it is recommended that the unit
be stored with its original protective packaging
To move the unit a short distance, the unit's floor support profiles facilitate handling with a pallet
jack or forklift.
When unloading and moving the unit, use a forklift with forks long enough to support the entire
length of the base. Otherwise, the forks should be long enough to support at least ¾ of said depth.
Transport with pallet jack
Page 8 of 24
GETEST