Controls For Mma Welding; Control Panel Tx 6271266 - Kemppi Protig 410 Operation Instructions Manual

3.1.12. Controls for MMA welding

1
1 Select the MMA welding.
2 Adjust with the +/- keys current needed.
Set value can be seen in display P23 on no-load. At welding the display shows welding current.
When the light H26 for remote control is lighted, you can control welding current from remote
control unit R10.
Don`t forget to change polarity of welding current by changing connection of cables as shown
in figures on page 4 or 5.
3.2.

CONTROL PANEL TX 6271266

H26 P23
S21 S22 S23
Read following paragraphs in operation instructions for panel TL:
Selection of MMA/TIG welding (S21)
Selection of TIG ignition method (S22)
Selection of operation mode of torch switch (S23)
Operation of control unit (S27), (S28)
Display for post gas time (P25)
Local and remote control of welding current (H26)
Welding current display (P23)
Controls for MMA welding
14 – PROTIG 410 / 0537
2
S29
S24 S51 P51 S27
P25
S28
© KEMPPI OY