Haier T3000 Manual page 37

2 The number in the upper black bar of the screen shows its row. Press the following keys to
continue operation:
CLR key: To Delete the picture you have taken and return to preview mode.
Camera side key: To save it in the picture album.
OK key: To access the list of available options, which are: Save, Modify, Send it via MMS or
E-mail or Infrared Ray, Take a new picture. Different modes will have different
options.
The number of pictures you can save in the phone will vary according to the settings
you have configured: the higher the resolution, the bigger the file size. A message will
warn you if there is not enough memory to store the picture you have just taken. In
this case, you must delete data (sounds, images, etc.) before storing a mew picture.
Stored pictures will be stored in Picture album automatically.
7.1.1.3 Self-timer
1 Set the self-timer option to On, press Camera side key on the right side to activate it. (Or press 0
key if the option is Off).
2 The countdown starts at –10 seconds (this value cannot be changed). A beep is played 3seconds
before the picture is taken, then again when it is actually shot.
Press CLR key to stop the timer and go back to preview mode or press 0 key to stop the timer.
7.1.1.4 Incoming call big picture
allows you to take picture and store the picture to a certain group. When the calls are from that
group, the fixed picture will flash on the screen.
7.1.1.5 Receive a call
When receiving a call while using the camera:
Answering the call: it will quit any action linked to the camera. Your phone will return to idle
when you hang up.
Rejecting the call: it will also quit any action linked to the camera, and will bring you bake to the
preview screen.
To make a call, you must first return to idle screen.
7.1.2 Settings
When the Camera is activated, press OK key to access.
Note: when quitting the camera application, settings you have defined will be saved and available
when reusing the camera or until you change them again.
7.1.2.1 General settings
Time and date: this option has three choices No date, Date only .Time and Date to modify your
picture.
Camera mode: it allows you to switch among different modes.
Picture quality: It allows you to choose an image quality available among the following: Low,
Medium, High.
Default settings: it allows you to change all values to default value.
7.1.2.2 Frame
Select frame allows you to select one and apply to your picture. When you select frame, the
resolution is set to 128*160pixles automatically.
7.1.2.3 Special effects
This option allows you to select one effect, like Normal, Grey, and etc. After you selected one, it