Table of Contents
Advertisement
6.6
MODBUS MASTER CONFIGURATION
Modbus master configuration is divided into two areas: a) setting up the slave(s), including diagnostics, and b)
defining the locations of the parameters to be read. Figure 80 shows an overview.
Section 5.4.7 shows the Modbus Master display page, and describes the configuration options available there.
Note: Versions 2.40 to 2.50 of the Mini8 Controller, and versions 2.70 to 3.20 of the Model 3550
controller are supported. It is not guaranteed that later software versions of these instruments
will be fully compatible.
Select configuration menu
Programmer
Modbus Master
EtherNet/IP
Digital I/O
User Lin
Custom Message
Zirconia
Data items that have been configured as
other than 'Off' are indicated by a green
triangle in the top right-hand corner.
Page 90
FEC920: USER GUIDE
Slave 1
Slave 2
1
2
3
4
5
Figure 80 Modbus Master configuration top level menus
A5E45696052A Rev-AA
Select configuration menu
Programmer
Main
Modbus Master
Diagnostics
EtherNet/IP
Digital I/O
User Lin
Custom Message
Zirconia
Select configuration menu
Programmer
Data
Modbus Master
EtherNet/IP
Digital I/O
User Lin
Custom Message
Zirconia
Section 6.6.1
Section 6.6.2
Section 6.6.3
September 18
Advertisement
Table of Contents
