Table of Contents
Advertisement
4.2
ELECTRICAL INSTALLATION
Figure 4 shows the locations of the various user terminations along with signal and supply wiring pinouts.
4.2.1 Termination details
The screw terminals accept single wires in the range 0.21 to 2.08mm
each in the range 0.21 to 1.31mm
Screw terminals should be tightened to a torque not exceeding 0.4Nm (3.54lb in).
Page 12
FEC920: USER GUIDE
2
(24 to 16 AWG) inclusive.
A5E45696052A Rev-AA
2
(24 to 14 AWG) inclusive, or two wires
A
September 18
Advertisement
Table of Contents
